2-8
Phaser 600 Color Printer
2
Installing the Printer and Drivers
Installing the pallet ramps
The shipping pallet contains two ramps that allow you to gently roll the printer
from the pallet to the floor. A space measuring about 6 meters (18 feet) long by
2 meters (7 feet) wide must be available to unpack and roll the printer off the
shipping pallet.
1.
Make sure that the leveling legs under the printer are screwed into the
printer as far as possible. This is necessary to allow the printer
enough clearance to be rolled to the pallet ramps.
2.
Using a 13 mm socket wrench, loosen and remove the two bolts
holding each ramp to the pallet platform.
3.
Lift the ramps off the pallet and place them into the openings on the
side of the pallet.
4.
Insert one bolt into each ramp at the point where the ramp rests on the
pallet. The bolts serve as pegs and are not tightened.
Figure 2-2 Installing the ramps
9482-120
