Tektronix MDO4000C Series, User Manual

Page: 83 / 160

FlexRay bus trigger
You can trigger on Start of Frame , Type of Frame , Identifier , Cycle Count ,
Header Fields , Data , Id & Data , End of Frame or Error .
Audio bus trigger
If you are using an I2C , Left Justified ( LJ ), or Right Justified ( RJ ) audio bus,
you can trigger on Word Select or Data .
If you are using an TDM audio bus, you can trigger on Frame Sync or Data .
USB bus trigger
You can trigger on Sync , Reset , Suspend , Resume , End of Packet , Token
(Address) Packet , Data Packet , Handshake Packet , Special Packet , or Error .
NOTE.
For triggering on a high speed USB bus (480 MB/s), use an oscilloscope
with 350 MHz or higher bandwidth.
Ethernet bus trigger
You can trigger on Start Frame Delimiter , MAC Addresses , MAC Length/
Type , TCP/IPv4 Client Data , End of Packet , Idle , or an FCS (CRC) Error . If
you turn on Q-(VLAN) Tagging , you can also trigger on MAC Q-Tag Control
Information .
Trigger setup
MDO4000C Series Oscilloscope User Manual 61
Preliminary