Locating Signals
The AM Mod signal is centered around ground.
Set the oscilloscope trigger level to either the top or bottom of the waveform to stabilize it on the display.
Single Shot Pulse
Board label.
SS_PULSE
Connector grid location.
C5, I4
Description.
This is a 200 ns wide positive pulse that is initiated by the SINGLE SHOT push button (grid location I4). The Demo
2 board provides one pulse per button push.
512 MHz
Board label.
512_MHZ
Connector grid location.
C6
Description.
This is a 512 MHz, 600 mV peak-to-peak sine wave signal that is enabled by the SINGLE SHOT push button
(grid location I4).
FlexRay
Board label.
FLEXRAY_BP, FLEXRAY_BM, FLEXRAY_TX/RX
Demo 2 Board Instruction Manual
125
Summary of Contents for DPO2000 Series
Page 2: ......