Locating Signals
Connector grid location.
C4, C5
Description.
These FlexRay signals consist of the following test points:
FlexRay_BP, the positive half of a differential FlexRay bus
FlexRay_BM, the negative half of a differential FlexRay bus
FlexRay_Tx/Rx, the single-ended logic signal between the controller and the transceiver
The data rate is at 10 Mb/s. The swing is 0 to 3.3 V. Tri-state is at 1.65 V (BP and BM only). There are 15 individual 198-bit
long frames.
Reset Button
Board label.
RESET
Grid location.
E7
Description.
Press the
RESET
button to start RS-232 signals from a common start point.
Single Shot Button
Board label.
SINGLE_SHOT
Grid location.
I4
Description.
Push the
SINGLE SHOT
button to initiate a 200 ns pulse and to enable the 512 MHz signal. The Demo 2 board
provides one pulse per button push.
126
Demo 2 Board Instruction Manual
Summary of Contents for DPO2000 Series
Page 2: ......
