Reference
Serial Mask Testing & Serial Pattern Trigger User Manual
29
Overview
Control elements and resources
Creating a new mask (cont.)
Setup pass/fail
testing
10.
Select the pass/fail test controls (this example uses the
defaults except Pass/Fail Test Repeat is selected):
H
The number of samples or waveforms to test, the
minimum number of waveforms to test, and the
delay before the test begins
H
Notifications/actions when the test fails or
completes
H
Polarity of the signal to test
H
Start the test and cause the test to repeat
View the test
results
11.
View the results of the pass/fail test (in this example
there have been no hits, and the current test is passing):
H
Pass/Fail Test Summary displays the number of
samples/waveforms tested, the total number of hits
(failures), and settings that you selected for the test
H
Hits per segment displays the number of hits in
each segment of the mask
H
Pass/Fail Test allows you to reset the test and to
turn the test on and off
Triggers set
automatically
12.
When you turn on masks, the instrument automatically
sets up the triggers. To see the trigger settings used by
this example, do the following step:
From the button bar, touch Trig. The instrument selected
Comm triggers, the Ch 1 source, HDB3 coding, the Data
type, and the DS1A standard, and set the bit rate and
pulse form.
For more
information
13.
For additional information on setting up and using serial
mask testing, refer to other sections of this user manual
and the instrument online help.
Summary of Contents for CSA7000 Series
