Operating Basics
6
Serial Mask Testing & Serial Pattern Trigger User Manual
Table 1: Masks control window functions (cont.)
Tab
Function
Pass/Fail Setup
Set the mask test pass/fail parameters
Pass/Fail Results
Display the pass/fail test results
To access the Serial Mask Testing communication trigger functions, do the
following steps:
1.
Touch the
Trig
tool bar button. The instrument displays the Trigger control
window.
2.
Select the
A Event
tab.
3.
Touch
Comm
in Trigger Type. The instrument displays the communication
signal trigger functions, as shown in Figure 2.
Figure 2:
Communication signal trigger functions
Table 2 describes the communication trigger functions. Refer to the
Reference
chapter beginning on page 11 of this manual, as well as the online help, for more
information about these functions.
Table 2: Communication trigger functions
Menu
Function
Source
Sets the waveform data source (Ch1-Ch4)
Type
Sets the waveform source type (Data, Clock, or Recovered Clock); the recovered clock function is not
available on the TDS7104 or the TDS7054, and is only available for NRZ coded signals
Polarity
Sets the edge (positive or negative) on which to trigger; this function is only available when Type is set to
Clock
Accessing Serial Mask
Testing Communications
Trigger Functions
Summary of Contents for CSA7000 Series
