Tektronix, Inc. DG2040, User Manual

Page: 83 / 266

Operating Basics
DG2040 Data Generator
2Ć49
Menubutton
FrontĆpanel
button
Side button popĆup menu Bottom button
Clear String
SEQ1 OK
The file called SEQ1.PDA is created. If a file of the same name already
exists, a message asking if that file should be overwritten will be displayed.
Press OK once more if that message is displayed.
The instrument has a function to move the specified pattern edges within the
range of
"
100 ps relative to the original position. You can specify the pattern
edge(s) in the DATA0 by using the DATA1 pattern.
In the following procedures, you create the pattern in the DATA0 as shown in
Figure 2-34, in which the highlighted edges are controlled and moved.
10 points 10 points
DATA1
DATA0
Figure 2Ć34: Pattern and edges to be controlled in the DATA0
To specify those edges to be controlled, you also create the pattern in the DATA1
as shown in Figure 2-34.
1. Follow the steps below to create a pattern in the DATA0.
a. Reset to factory setting.
Menubutton Bottom button popĆup menu Side button
FrontĆpanel
button
UTILITY System Reset to FactoĆ
ry
OK
Tutorial 5: Controlling
Pattern Edges