TECO E510-201-SH, Instruction Manual

Page: 106 / 425

4-40
* If the maximum output frequency of motor is over 300HZ, the frequency resolution is changed to 0.1Hz
Note：The parameter of 11-01 can be changed during run operation, the range is 1~16KHz.
Group 12 Monitoring Parameters
Code Parameters Setting Range Default Unit
Control Mode
Attribute
V/F SLV
PM
SLV
12-00
Display Screen
Selection (LED)
00000~88888
From the leftmost bit, it displays the
screen when press DSP key in order.
0：no display
1：Output Current
2：Output Voltage
3：DC Bus Voltage
4：Heatsink Temperature*
5：PID Feedback
6：AI1 Value
7：AI2 Value
8：Counter Value
00000 - O O O
*1
*6
12-01
PID Feedback
Display Mode (LED)
0：Display the Feedback Value by
Integer (xxx)
1：Display the Feedback Value by the
Value with One Decimal Place (xx.x)
2：Display the Feedback Value by the
Value with Two Decimal Places (x.xx)
0 O O O *6
12-02
PID Feedback
Display Unit Setting
(LED) 0：xxxxx (no unit)
1：xxxPb (pressure)
2：xxxFL (flow)
0 O O O *6
12-03
Line Speed Display
(LED)
0~60000
1500/
1800
RPM O O O
*1
*6
12-04
Modes of Line
Speed Display (LED)
0：Display Inverter Output Frequency
1：Display Line Speed with integer (xxxxx)
2：Display Line Speed with the First
Decimal Place (xxxx.x)
3：Display Line Speed with the
Second Decimal Place (xxx.xx)
4：Display Line Speed with the Third
Decimal Place (xx.xxx)
0 - O O O
*1
*6
12-05
Status Display of
Digital Input &
Output Terminal
(LED/LCD)
LCD display is shown as below - O O O *4