TECO E510-201-SH, Instruction Manual

Page: 419 / 425

WARNING
The misuse of safety function leads to personal injury or death, property damage, or
economic loss. To ensure that the system complies fully with requirement of safety, make a
system-level risk assessment. TECO Electric Co. cannot assume responsibility for any system
to comply with safety directive.
Installation and wiring
CAUTION
The following information is merely a guide for proper installation.
TECO Electric & Machinery Co. cannot assume responsibility for the compliance or the
noncompliance to any code, national, local or otherwise for the proper installation of this
equipment. A hazard of personal injury and/or equipment damage exists if codes are
ignored during installation.
CAUTION
Ensure the safety relay unit and the 11-301 unit is mounted closely in open type and all
interconnection wiring is short and protected against open and short circuit faults. Refer
EN/ISO13849-1.
Installation
TECO 11-301 safety stop function should be used under following condition and environment.
Table.1 The condition and environment for using safety stop function
Item Condition
Temperature
range
Operation
-10°C to +50°C inside distributor (without stick on type dust cover)
-10°C to +40°C inside distributor (with stick on type dust cover)
Storage
-20°C to +60°C
Ambient humidity 95%RH maximum (non-condensing)
Shock
1G. (9.8m/s²) for 20Hz and below.
0.6G (5.88m/s²) from 20Hz to 50Hz (Compliance with IEC 60068-2-6)
Altitude maximum 1000m above sea level
Atmosphere Indoors (without corrosive gas, flammable gas, oil mist, dust and dirt etc.)
Over voltage category II or less
Pollution degree
II or less
Mounting
wall mounting / vertical orientation