TechVision PS8E1N2, Manual

Page: 76 / 121

Alarm Management DVR User Manual
70
the duration time is set to 10 seconds, once the system detects a motion, it will go to alarm and
would not detect any other motion (specific to camera) in 10 seconds. If there is another motion
detected during this period, it will be considered as a continuous movement; otherwise it will
be considered as a single motion.
③
Drag the camera image to set the motion area. You can set more than one motion area.
Click “All” to set the whole camera image as the motion area. Click “Reverse” to swap the
motion area and the non-motion area. Click “Clear” to clear all the motion areas.
④
Click “Apply” to save the settings. Click “Processing Mode” to go to the alarm handling
configuration interface of the motion alarm.
9.2.2 Motion Alarm Handling Configuration
①
Click Start

Settings

Alarm

Motion Alarm to go to the following interface.
②
Enable or disable “Snapshot”, “Push”, “Alarm-out”, “Preset”, “Buzzer”, “Pop-up Video”
and “E-mail”. The alarm handling setting of motion alarm is similar to that of the sensor alarm
(see 9.1 Sensor Alarm for details).
③
Click “Apply” to save the settings. You can click “Motion Settings” to go to the motion
configuration interface.
9.3 Intelligence Alarm
9.3.1 Object Detection
Object Detection Configuration :
①
Click Start

Settings

Camera

Intelligent Detection

Object Detection to go to the
following interface.
②
Select the camera, enable the object detection and set the duration and detect type. There
are two detect types: Abandoned object and missing object.
Abandoned object : Alarms will be triggered if there are articles left in the pre-defined
detection area.
Missing object : Alarms will be triggered if there are articles missing in the detection area drew
by the users.
③
Select the alarm area. A maximum of 4 alarm areas can be set.
④
Draw the alarm area of the object detection. Refer to the interface as shown above. Check