TechVision PS8E1N2, Manual

Page: 30 / 121

Camera Management DVR User Manual
24
4 Camera Management
4.1 Camera Signal
Click Start

Settings

Camera

Manage Camera

Camera Signal to go to the interface as
shown below.
Some models may support analog signal switching to IP signal, which means decreasing (or
increasing) the number of analog channels, accordingly increasing (or decreasing) the number
of IP channels with the total channels unchanged.
The DVR device supports hybrid access of TVI, AHD, CVI and CVBS high definition cameras.
If the TVI high definition camera is accessed to the DVR, you should select TVI in the
following interface to show the camera image normally; if you select AHD, then there will be
no image or the image has no color. The default selection of the camera signal is Auto. If you
select Auto, the image of the camera will be shown normally regardless of the camera type.
Note: You can enable “Lite” in the interface if the DVR supports “Lite” recording. It will lower
the recording resolution and increase the recording frame rate. Please enable or disable the Lite
as you wish.
4.2 Add/Edit Camera
4.2.1 Add Camera
The network of the DVR should be set before adding IP camera (see 11.1.1 TCP/IP
Configuration for details).
Refer to the pictures below. Click Add Camera in the setup panel or in the top right
corner of the preview window to pop up the “Add Camera” window as shown below. You can
quickly add or add the IP camera manually.