Page 54 • MNF18001EN / DOK-479-E ║ Issue/Rev. 1.4 (9/18)
The following display appears:
<Display test>:
All ASCII characters are displayed;
the test ends automatically.
<Own-address>:
(CAN bus address) The
<F1>
and
<F2>
keys,
“plus”
and
“minus”
are
then used to set the respective CAN
address. It is stored with
<F3> “End”
.
Display Interface 1: address 0
Display Interface 2: address 1
Display Interface 3: address 2
Display Interface 4: address 3
Node number
‘0’
must be set for the display of the ‘Main Unit/Display’ module
MLMAINDISP. For an additional display in the case of, for example, ‘left/left/
right’ tank truck, set node number ‘1’.
If a chip card reader CCR exists, it must always be connected to the display
with the node number
‘0’
!
<Keyboard test>:
A keyboard test can be carried out with this menu item. With each actuation of a
key the latter is represented with its corresponding identification in the row. The
test can be exited by pressing the <ENTER> key twice.
<Contrast>:
The range of values for the contrast of the display is (0 – 100) and is adjusted
with:
<F1>
for ‘lower contrast’, or with
<F2>
for ‘higher contrast’ and confirmed with
<F3>
for
‘End’
.
(default value about:
‘40’
)
The display interface features automatic contrast adjustment, dependent on the
temperature. Correction is not normally necessary.
<Char table>:
Setting of the character sets (PC437, PC852, PC866) with
<F1>
for "plus" and
with
<F2>
for "minus" and
<F3>
for "end" and adoption of the newly-set value.
(default value: "PC437").
The preset character set may be changed only after consulting F. A.
Sening!
<End>:
The setup / test is terminated by selecting the line:
"End"
with the function keys
and pressing the
<Enter>
key.
After ending the setup settings/ tests, the MultiLevel system should be switched
‘OFF’
and
‘ON’
again.
MultiLevel Instruction Manual
Commissioning
Summary of Contents for Sening MultiLevel
