CM 100 High
User Manual
39
Working as DLT-port
:
If you want to establish a TCP-Connection on this port to any connected device on the
BASE-T1 ports, you have to activate this function. Please also configure the
IP for
Injection
. For further information please see
C
TCP-Connection possible
TCP-Connection not possible
Keep Awake Reason Bus
:
This port is supervised. If on this port is communication, CM_100High
can’t go
asleep.
This port is not supervised. The Capture Module can fall asleep even there is
communication on this port.
Cascade to
:
None
: forwarding of incoming traffic
GB-A
: forwarding of incoming traffic to GB-A
GB-B
: forwarding of incoming traffic to GB-B
GB-C
: forwarding of incoming traffic to GB-C
802.1AS mode
:
Disabled
: there is no synchronisation with other PTP-partners
Bridge Slave
: the connected device on this port must be a bridge master of
ptp-protocol
Bridge Master
: the connected device on this port must be a bridge slave of
prp-protocol
802.1AS Master
: This port is generating the master clock for the logging
system
Note
: Ports configured as Bridge Master or bridge Slave can be cascaded as well
Note:
If there is already one port defined as Bridge-slave there is no more a Bridge-
Slave-port or 802.1AS Master-port possible.
IP for Injection
: If you want to get direct access to a device connected on a 100BASE-
T1 Port by this GB-Port through a TCP-connection, you must apply here the IP-address
of the connected device on this GB-
Port. Don’t forget to do this
on the 100BASE-T1
port, too.
If the function
Use PLP Header
on SPY multiplexer is activated (see
C
P
lease don’t forget to s
et an
Advance filter
with logging
without PLP
for the reply of
the device connected to the 100BASE-T1 port (ARP-Target filter and IPv4 Destination
filter). Please, activate the function
Working as DLT-port
, too.
For further information please see
C
