Figure 2:
Rear Panel of the veloCD ReWRITER Internal Drive
•
Audio output connector: Outputs stereo analog signal. Use to connect to soundcard or audio amplifier.
Use standard MPC-3 type, 4-pin connector.
•
Jumpers: Use to select operation as an IDE master or slave, or for cable select. In general, leave
these jumpers at their factory settings.
•
IDE cable connector: Connects to IDE interface using 40-pin IDE flat ribbon cable.
•
Power connector: Connects to your computer’s power supply to provide
DC +5V and +12V to the veloCD ReWRITER.
4
veloCD ReWRITER :
User’s Manual
Audio
CSEL
E-IDE Interface
Power
Slave
Master
39
40
1
2
Digital
D G
R G G L
5V G G 12V
Analog
Power
connector
IDE cable
connector
Jumper
(not used)
Audio output
connector
AUDIO OUT
R G L
CABLE SELECT
SLAVE
MASTER
Jumpers
40
IDE
DC INPUT
1
+5V GND +12V
