Figure 8:
Removing the Cover Panel from a Bay
Figure 9:
Installing Mounting Rails (if needed)
Be sure not to mistake the inner and outer face of
the rail when attaching. Typically, the smooth side of the rail faces away from the drive’s chassis.
5.
Plug a free connector on the IDE cable into the IDE connector on the rear panel of the drive before
you insert the drive into your computer. Then thread the cable through the front of the open bay and
back toward the motherboard. The drive should slide smoothly into the bay. If it does not, check for
obstructions in the bay and ensure the side rails (if needed) are attached properly.
6.
If not already connected, attach one end of the IDE ribbon cable to the connector on the motherboard.
SECTION 2 :
Installing Your veloCD ReWRITER
11
Available bay with
cover panel removed
NOTE:
TDK does not provide rails. If you need rails, you
can obtain them from the computer manufacturer or
from a computer supply retail or mail-order store.
