FCC NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy, and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee interference
will not occur in a particular installation. If this equipment causes harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications should be approved by the party responsible for compliance of
FCC Rules, otherwise, the user loses authority to operate the equipment.
The laser beam emitted from the optical pickup is invisible. Accordingly:
•
Do not open the optical pickup housing.
•
Obtain service only from TDK-authorized personnel.
LASER INFORMATION
These products have been designed and manufactured according to IEC 825-1 on the Safety of Laser
products. This product comes under "Class 1 Laser Products." A Laser Caution Marking is attached
on the top of the internal drive model: "Caution: Invisible laser radiation when open. Avoid direct
exposure to beam."
CAUTION:
Use of controls or adjustments or performance
of procedures other than those specified herein may
result in hazardous radiation exposure.
CAUTION:
To disconnect the CD-R drive from an electrical
current, pull out the AC power cord.
CONGRATULATIONS!
Thank you for purchasing your veloCD ReWriter, a reliable, high performance CD
rewriter, recorder, and reader. We appreciate the confidence you have shown in us.
The key to the superior performance of the veloCD burner is the inclusion of
buffer underrun write assurance technology, which eliminates buffer underrun
errors. These errors – which are fatal to the writing process – result from
momentary interruptions in the data flowing to the write laser. They typically
occur when the user tries to perform another task during the writing process
or when the source cannot supply data fast enough to the writer.
To prevent buffer underrun errors, the veloCD continuously monitors the status of
its built-in buffer memory. When a buffer underrun error is about to occur, the
veloCD suspends recording until the buffer is refilled. To continue recording at the
appropriate place, the veloCD drive compares the recorded data with the data in its
buffer memory and synchronises adjacent frames. With this technique, the drive
restarts recording at the precise position where writing was originally suspended.
1.
Clicking on the desired subject
heading takes you to it's
location
in the manual.
Utilize Adobe Acrobat’s Bookmark palette.
2.
Clicking on a page number
within the manual takes you
back to the T
able of Contents.
1.
Click the Navigation Pane and select the Bookmark T ab.
2.
Click the desired subject entry to go to its page within the manual.
OPTION 2:
OPTION 1: Toggle between the TABLE OF CONTENTS and specific topics.
NAVIGATION
