8
DOOR Series -
English
pulled the cable taut from the outlet of tube H so that it remains in this condition but without the mobile part A being lifted, tighten the
screw of clamp I as near as possible to adjuster L. Regulate this adjuster until the releasing wire is taut. Release ring N can now be
fixed with clamp M at the required height. In doors with one wing that open towards the right, the position of the components is directly
opposite to the ones shown in the drawing, but the operations to carry out are exactly the same.
fig. 14
At this stage, the H release device must be prepared as follows (wall mounted):
Locate the exact point on the wall where the device is to be mounted,
bearing in mind that the standard cable sheathing is 50 cm long
(a kit
containing a 300 cm length cable is also available).
Drill a hole in the wall, and fasten the base of the release
mechanism using special screws. Attach the adhesive label as
shown in the figure, making sure the four black bands correspond
to the cardinal points.
Insert the adjuster with 2 nuts, one in the relative slit in the plastic
and the other on the outside of it.
Thread the release cable through the bottom slot, then into the
adjustment register. Then place the cable terminal on the release
knob cable clamp
.
At this stage, slide the release knob into the base of the mechanism
taking care to keep the cable terminals
in the cable clamp seat,
and the knob in the correct position. The cable terminal must
be set just after the lower fastening screw (clockwise) when the
knob is inserted
.
1
2
3
4
