82
GNCRP / GNCRPE / GNCRPE 230 - Rev. 03 - Aug/22
15. To carry out any verification on the equipment, lower it to the ground and
shut down the tractor engine.
16. Whenever unhitching the equipment, either in the field or shed, do it on
a flat and firm place and use the jacks. Make sure that the equipment is
properly supported.
17. Carry out the operations on a controlled and careful manner.
18. As stated before, the maneuvers must only be done to the left hand side,
where the disc gangs are closer to each other.
19. Relieve the control valve pressure before disconnecting the quick couplers
and when doing any verification in the hydraulic cylinders.
20. The tractor drawbar must remain fixed during work and transportation.
21. Do not check eventual leaks using your bare hands, as the high pressure
may cause body injury. Use a cardboard or any other suitable object instead.
22. As previously mentioned, this disk harrow has several settings. However,
only the local conditions can determine its best adjustment.
7. Adjustments and operations
Operations - important points
IMPORTANT
- Before retightening the disc gangs, it is necessary to loosen up the bearing fixation
bolts.
