46
GNCRP / GNCRPE / GNCRPE 230 - Rev. 03 - Aug/22
5. Assembly
Disc gangs assembly sequence
1. Place the outer lock (A) along with the axle (B).
2. Place a disc blade (C), bearings (D), shims (E) and spacer spools (F), following the
instructions on the previous pages.
3. Place the inner lock (G) and the axle nut (H) passing 5 mm from the axle face.
4. Place the bolt (I) along with washers (only on the outer side of the gangs).
5. Use the wrenches from the 'set of wrenches' page and tighten the gangs:
a) Place one of the wrenches on the outer side of the gangs (locked side) and support
it on the soil (as shown on the next page).
b) Use the other wrench on the inner side and tighten the gangs until it reaches the
maximum torque.
c) To tight the gangs, keep them underpinned using a wood or similar object (as
shown on the next page).
IMPORTANT
- Check the correct side of the bearings and spacer spools according to the disc blades
concavity.
- GNCRP: 32 to 60 disc blades
- GNCRPE: 36 to 60 disc blades
Plug
Plug
DM bearing
DM bearing
