70
GNCRP / GNCRPE / GNCRPE 230 - Rev. 03 - Aug/22
6. Set-up instructions
Preparing the equipment
The equipment must always be parked on a dry and flat place, free from any debris or
strange objects. Follow this procedure to set the equipment up:
1. Clean up to remove strange objects from the equipment and from the working area;
2. Make sure that there is enough room to maneuver the tractor until it hitches to the
equipment;
3. Turn on the tractor and slowly approach it to the hitching point direction;
4. Use a clean cloth or a paper towel to clean the couplers in the end of the hoses. Also,
clean the area around the tractor couplers;
5.
Check the tires inflation and keep the same pressure on all of them (check 'tires
inflation' page in the 'maintenance' section).
6.
Lubricate all grease fittings appropriately (see the 'lubrication' page in the
'maintenance' section).
Hitching to the tractor - hydraulic connection
1. Approach the tractor and couple
the hoses (A) to the quick couplers.
2. To do so, shut down the engine,
relieve the control valve pressure
by activating the lever a couple of
times.
3. Check if the quick couplers are
clean.
Tractor
Tractor
PTO
PTO
A
A
1. Check the drawbar type from your tractor. To hitch the equipment, use the tractor
drawbar.
2. The tractor drawbar must always remain fixed and centered during operation.
Hitching to the tractor
WARNING
- When setting up the equipment for the job, the tractor-equipment must be leveled
related to the soil. Besides that, the tractor must be hitched to the equipment hitch
to avoid unnecessary efforts during the set-up.
- GNCRP: 32 to 60 disc blades
- GNCRPE: 36 to 60 disc blades
