TANDBERG RDX QuikStation, Product Manual

Page: 24 / 130

14
P
RODUCT
M
ANUAL
1019786
C
HAPTER
2—I
NSTALLATION AND
S
ETUP
I
NSTALLING THE
O
UTER
R
AILS INTO THE
R
ACK
The front and back of the rails attach to the rack with a bar nut, two
washers, and two #10 pan-head screws, as shown in the figure below.
Securing the front of the rail to the rack
1. Place an outer rail against the inside flange of the rack post (see figure
above). Make sure you orient the rail so that the bracket (either the rail
extension or the short bracket) faces the back of the rack.
2. Place a bar nut flush against the end of the rail (see figure above). Position
the rail and bar nut so that the bar nut’s bottom hole and middle hole align
with rack holes that are 0.5" apart (see figure above).
3. Thread the screws through the washers, the rack post, and the bottom and
middle holes of the bar nut (see figure above).
4. Install a clip nut in the hole directly below the bar nut (see figure above).
Securing the back of the rail to the rack
1. Line up the rail with the back placement holes in the rack. Make sure the
rail is against the inside rack flange and is level to the ground.
2. Thread the screws through the washers, the rack post, and the bottom and
middle holes of the bar nut (see figure above).
3. If necessary, adjust the rail so that it fits snugly into the rack. Tighten the
two #10 pan-head screws that attach the bracket to the outer rail.
Repeat these steps to attach the other outer rail and clip nut to the rack.
Figure 2-2 Attaching the outer rail to the rack
Front of Rack
outer rail
rail extension bracket
Back of Rack
clip nut
bar nut
0.5"
0.625"
washers
#10 pan-head
screws