TANDBERG RDX QuikStation, Product Manual

Page: 16 / 130

6
P
RODUCT
M
ANUAL
1019786
C
HAPTER
1—P
RODUCT
O
VERVIEW
RDX D
OCK
LCD P
ANELS
The eight RDX dock LCDs display information based on the conditions that
are described in the following table
Condition
What is displayed in LCD Dock Panels
Upon initial startup of
the unit and before a
logical device type has
been selected.
The firmware level, system name, IP status (DHCP or
static), and a valid IP address (if DHCP is enabled)
continuously display until you select a logical device
type from the Remote Management Console.
After a system restart. The firmware level, system name, IP status (DHCP or
static), and IP address display in sequential order for
a few seconds. For RDX docks that have a loaded
cartridge, the cartridge label number displays in the
LCD panel.
When a USB flash
drive is inserted into
the front-panel USB
port.
“LogDump” displays. When the system log dump is
complete, the LCD panels display “PASSED.”
If one of the following files is loaded on the USB stick:
network.conf : “NetUpdate” displays. When the
configuration download is
complete, the LCD panels display
“PASSED.”
password.reset : “RstPasswd” displays. When the
password reset is complete, the
LCD panels flash “DONE.”
vtx.fw : “CodeUpdate” displays. When
the firmware update is complete,
the LCD panels display “Remove
stick to reboot.”
An RDX cartridge is
loaded in a dock.
When the dock is configured as eight removable
disks, the LCD panel displays the last eight digits of
the cartridge serial number.
When the dock is configured as a tape library slot,
the LCD panel displays an LTO-3 “tape label”, which
consists of the last six digits of the cartridge serial
number followed by “L3.”
An RDX dock is empty. Nothing is displayed.