General Use
75
3.11.1
Presentation Key
The quickest way to show a presentation is to use the presentation key on the remote control.
The presentation key is used to start and stop a presentation. The presentation key will display
PC (default*).
When holding the presentation key for 1 second, the presentation menu will be displayed. This
menu allows you to choose other video sources.
You can also find the Presentation button in the Menu on screen. Select Presentation button and
press OK on remote control.
The default presentation source can be permanently changed in
Presentation Settings
.
When using the presentation key, your presentation will be displayed as a
Dual Stream
, if
possible. If the call does not support a dual video stream, the presentation will display as main
video stream.
How to start and end a Presentation using the Presentation key:
1. Press the Presentation key. The video source that is set as presentation source is
displayed in full screen (PC is default). Remember to connect your
PC
to the codec in
advance.
2. Press the Presentation key again to end the presentation and go back to main camera.
* If available on your system.
Summary of Contents for 8000 MXP
