TANDBERG 8000 MXP
14
2.2 Connecting Cables
All cables needed in standard configuration are connected to the system. Connect these cables
to the other parts of the system:
1. Power cable
Connect the system power cable to an electrical distribution socket.
2. Monitor cables
Connect to the DVI input of each monitor the 1,5m DVI-DVI cable and the power cable. You will
find the cables coiled up in the base. There will be a coil for each monitor. Switch on the
monitors. Make sure that the cable marked "Main Monitor" is connected to the main monitor
and that the cable marked "Dual Monitor" is connected to the dual monitor.
3. Microphone cable
Connect the microphone cables to the microphones.
4. Camera cable
When installing the Precision HD Camera, please follow the instructions in the enclosed
Installation Sheet for TANDBERG 8000 MXP. Installation Sheets are also found on the User
Manuals CD.
NOTE! The enclosed TANDBERG Camera Cables must be used! Do not use other camera
cables as this might cause problems with the transfer of video signals from the Precision HD
Camera.
5a. ISDN cables - using BRI interface
Connect the ISDN cables to the ISDN sockets (S/T-interface) provided by the service provider.
The main number will be the number associated with the socket to which ISDN cable number 1
is connected.
NOTE! The system does not have a built in network terminator. If wall socket provides an
ISDN U-interface, a NT1 between the system and the ISDN line is needed, see
Appendix
10
for more information.
5b. ISDN cable - using the PRI interface
If using the PRI interface, the E1/T1 cable should be connected to a CSU (Channel Service
Unit). A CSU between the system and the PRI line from the network provider is needed, see
Appendix 8
.
5c. Other networks - using the External Network interface
If using other networks, please refer to chapter
ISDN/External/Leased E1/T1
and
Appendix 9
.
6. LAN cable
To use the system on LAN, connect a LAN cable from the ‘Ethernet’ connector on the system to
the LAN.
Summary of Contents for 8000 MXP
