- 13 -
Fig. 2 Model AD-6 Operator Panel
(1)
DISP CHANGE Key:
Press this key to toggle between the STANDBY and RUN screens.
(2)
PRINT Key:
Press this key to reprint test results, plot distillation curves, and to print
temperature correction values, test parameters, and other settings if optional printer is installed
(3)
MANUAL CUT Key:
Press this key to stop testing manually.
(4)
FUNCTION Key:
Press this key to change from the RUN screen to the Distillation Curve screen
while a test is running. Also, the menu can be displayed by pressing this key and the RESET
key at the same time.
(5)
Up and Down Keys:
Use these keys to select a test mode (long cursor) or to change an item
or increment or decrement a value at the cursor (short cursor).
(6)
Left and Right Keys:
Use these keys to move the cursor (short cursor). This is mainly used
when changing test parameters (on the STANDBY screen).
(7)
Enter Key:
Use this key accept the mode name and move the cursor to the test parameters to
allow them to be changed.
(8)
RUN Lamp:
Lights at the start of a test. (Red)
(9)
COOL Lamp:
Lights while the heater section is cooling after a test. (Green)
(10)
START Key:
Press this key to start a test.
(11)
COOL Key:
Press this key to cool the heating section as required. If this key is pressed during
testing, the test is terminated and the heater section cooled for 10 minutes.
(12)
RESET Key:
This key is mainly used to abort testing or cooling. Pressing this key returns the
tester to the standby state and displays the STANDBY screen shown in Fig.5 on Page 18.
(1)
(2)
(3)
(4)
(5)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(6)
Summary of Contents for AD-6
Page 2: ...1 Blank Page...
Page 9: ...8 Blank Page...
