Tally T6215, Maintenance Manual

Page: 85 / 164

4–15
Chapter 4: Removing and Replacing Components
Procedure 9: Shuttle Removal
Step 1. Remove the Ribbon Platform (see Procedure 1).
Step 2. Remove the Hammer
B
ank (see Procedure 5).
Step 3. Remove the two screws which hold the shuttle frame to the Hammer Bank.
Figure 18. Removing Shuttle screws.
Step 4. Remove two screws (9/64" Allen) through the center of the shuttle and to the
outside edge of the shuttle, then lift the shuttle from the Hammer Bank.
He
x Head Scre
w
Hex Head Screw
Figure 19. Removing screws from inside shuttle.
When reinstalling the Shuttle to the Hammer
B
ank, start all four screws until
they are snug, but do not tighten. Tighten the two Allen screws first.