Tally T6215, Maintenance Manual

Page: 39 / 164

2–13
Chapter 2. Menu Operations
Motors
This parameter provides a means for testing individual motor circuits by turning them on or off.
They can be tested at the current selection (Default) or you can select a variety of speeds at
which to test them. (See
Shuttle Speed parameter and Ribbon Weld parameter.)
Accessing the Motor Tests:
Step 1. Take the printer offline and place it in Tech Access Mode.
Step 2. With the printer display reading OFFLINE , depress the Menu/Back Key and use the
▲
/
▼
keys to scroll to TEST .
Step 3. Press Enter and scroll (
▲
Key) to Diag .
Step 4. Press Enter and scroll (
▲
Key) to Motor .
Step 5. Press Enter and scroll (
▲
Key) to either Ribbon or Shuttle. Each Motor Test is initiated
by depressing the Enter key when the desired selection is displayed.
Motor selections
Ribbon
Shuttle
Ribbon Pump (Remove ribbon before performing this test.)
Blower
Remove the ribbon before performing the Ribbon Pump test!
The selected test is initiated by depressing the ENTER Key. After the motor reaches its assigned
speed the test can be stopped by depressing the ENTER Key again. This sequence may be
repeated until you are satisfied with the operation of the motor. (The Paper Feed Motor may be
tested using the LF (line feed) or FF (form feed) functions.).
Shuttle Speed
This option provides a means to vary the Shuttle Motor speed for a Shuttle Motor Test.
Shuttle Speed selections:
20-99 Hz.
Ribbon Speed
Provides a means to vary the Ribbon Motor speed for a Ribbon Motor Test.
Speed selections:
1–250
Default