Tadiran Telecom Coral IPx 500X, Installation Procedure And Hardware Reference Manual

Page: 96 / 400

3-6
Coral IPx 800 Installation Manual
Po
wer Sup
ply T
est
3
0
The PS19 AC internal circuitry automatically adjusts itself to the input voltage
(either 115 VAC or 230 VAC). No voltage adjustments need or be performed
during installation.
1. Verify that the ground wires and the power wires are properly connected.
See
page 2-17, Ground Wiring
and
page 2-25, Wiring AC Powered Systems
.
2. Verify on the cage rear panel that the POWER SUPPLY DUPLICATION connector
is not in use.
3. Verify that the AC voltage supplied by the AC receptacle is 115VAC or 230VAC.
4. See figures on
page 2-25, Coral IPx 800 Cage Rear Panel
page 2-26, Coral IPx 800 Power Connection for AC Systems
5. Insert the male plug of the AC power cord into the AC line outlet or primary
power receptacle designated for the system.
4 AC Powered System
Connecting the POWER SUPPLY DUPLICATION connector (located on the cage rear
panel) for PS19 AC power supplies will result in damage to the system. This connector
is only used with the PS19 DC-D power supply. Do not use this connector when the
PS19 AC power supply is installed.
The AC power connector inside the cage includes dangerous currents when the AC
power cord is connected. See Figure 3-1 .
Do not connect more than four cages to the same facilities AC fuse. Connecting more
than four cages to the same fuse could result in an overload within the building wiring. It
is the customer’s responsibility to supply the facilities AC fuse.