Tadiran Telecom Coral IPx 500X, Installation Procedure And Hardware Reference Manual

Page: 65 / 400

Hardware Installation Procedure
2-25
Eq
uip
m
ent Insta
lla
tio
n
2
0
This section describes how to connect the power wires to the Coral IPx cage for AC
powered systems (that is, when the PS19 AC power supply card is installed in the
cage). For instructions on how to connect power wires to DC powered systems, see
page 2-22, Wiring DC Powered Systems
.
Do one of the following:
„
For cages that include an AC cord with bare wires, attach the appropriate AC
power connector to the end of the AC power cord according to local requirements,
and route the cord to the designated power outlet. For more information, see
page
6-21, Installing the AC Power Cord
.
„
For cages that include an AC cord with a plug already attached, route the power
cord to the designated power outlet.
Figure 2-14 Coral IPx 800
Cage Rear Panel
5 Wiring AC Powered Systems
Do not connect the AC power cord to the outlet at this time. The AC power connector
inside the cage includes dangerous currents when the AC power cord is connected.
Do not connect more than four cages to the same facilities AC fuse. Connecting more
than four cages to the same fuse could result in an overload within the building wiring. It
is the customer’s responsibility to supply the facilities AC fuse.
AC power
cord
Ground
connection
nut
DC power
(not in Use
for AC Connections)