Tadiran Telecom Coral IPx 500X, Installation Procedure And Hardware Reference Manual

Page: 80 / 400

2-40
Coral IPx 800 Installation Manual
Eq
uip
m
ent Insta
lla
tio
n
2
Service and Peripheral Cards Installation Manual , for more information about
synchronization.
„
Insert peripheral cards into slots 1 through 8 of the main cage and slots 2
through 12 of the expansion cages.
2. If IPx 500X expansion cages are installed determine the position of peripheral
interface cards that will be inserted into card slots 1 through 10 in the expansion
cage. Observe any order previously directed by a system designer or any
established convention of the distributor. The card placement diagrams,
Figure
2-22
through
Figure 2-23
, may be used as a worksheet by the system designer to
establish card placement prior to installation. Refer to the Coral IPx 500 Installation
Manual Chapter 2
and the Coral Service and Peripheral Cards Installation Manual.
Place digital trunk interface cards in card slots 4 and/or 5. Slots 4 and 5 are wired
as the primary and secondary external clock source, respectively. The cards
inserted in these slots can be used to synchronize the Coral IPx system clock with
a network clock signal derived from a digital trunk circuit.
If no other convention exists, refer to Section 10, Peripheral Cards Installation of the
Coral IPx 500 Installation Manual
.
3. Remove shared service and peripheral interface cards from their shipping cartons
and partially insert them into the card slots as determined above. Allow the cards
to protrude from the card cage by approximately 1 inch (2.5cm).
4. Go to
page 2-47, Program Interface Device Connection
.