TA Instruments TMA 2940, Operator'S Manual, Page: 39 / 176

TA I
NSTRUMENTS
TMA 2940 2–5
6. Slide the unit completely onto the lab bench.
Have your assistant hold one side up while
you unscrew and remove the black rubber
vibration mounts from the bottom. Then
rotate the unit and remove the vibration
mounts from the other side in the same
manner.
7. Remove the ¼ x 20 screws and mounting
feet from the accessory kit. Place the screw
through the center of the rubber feet.
8. Have your assistant lift the entire unit while
you slide the plywood board out from under
it.
9. Have your assistant lift one side of the unit
while you install two of the mounting feet
(see Figure 2.3). Rotate the unit and install
the two remaining mounting feet in the same
manner.
Figure 2.3 Installing
the Mounting Feet
Unpacking the TMA