Using Your Options
TA I
NSTRUMENTS
TMA 2940
4–18
Accessory
Installation
The flexure accessory uses a special flexure
probe and sample platform, and the standard
stage.
1. Remove the existing probe as instructed on
page 2-19.
2. Install the standard stage, if it is not already
in place. (For instructions to install the
stage, refer to page 2-14).
3. Install the flexure probe in the same manner
as the standard expansion and penetration
probes as instructed on page 2-18.
4. Change the instrument mode, if necessary.
Calibration
The flexure probe should be calibrated as you
would normally calibrate any of the standard
probes. See the
Thermal Solutions/Advantage
User Reference Guide
for details.
Summary of Contents for TMA 2940
