FLANGING MACHINE
53
F-400
6.7.3 THE WORK CYCLE OF THE BEVELLING OPERATION
1. Install the bevelling tool.
2. Fasten the tube into the clamp
3. Regulate the creeping speed of the forward movement of the carriage by closing the
valve, and then open the valve by 1/5 of a turn.
4. Carry out the settings of the forming tool and select suitable program from display.
L
DANGER! Before starting the automatic work cycle, make sure that the
tube has been clamped properly.
5. Press the push-button. The machine performs the automatic work cycle.
L
DANGER! If the spindle does not rotate evenly or it stops, interrupt
the work cycle immediately by pressing the EMERGENCY STOP button
completely down.
6. Check the swarf thickness. If the carriage speed is not correct, stop the machine and
adjust the speed of the carriage movement. At the end of the cycle the spindle will stop
automatically in the right position, ready to perform the following cycle.
¨
NOTE! The tube end may be hot after the bevelling operation.
7.Loosen the bevelled tube, inspect the result and the quality of the operation, and make
corrections if necessary