![background image](http://html1.mh-extra.com/html/t-drill/f-400/f-400_instruction-manual_3075621031.webp)
FLANGING MACHINE
31
F-400
6.3.2 CHANGING OF THE FORMING PIN
L
DANGER! Before closing the clamping jaws make sure they can move
freely - the jaws may crush your hands!
1. Start the machine by pushing the push-button
.
2. Close the clamping jaws by turning the clamp control switch to
, in order to
pressurize the hydraulics. Keep the switch in this position until the jaws are closed.
3. Drive the carriage in the rear position by turning the control switch of clamps in
position
and turn at the same time the control switch of the carriage to the position
(reverse carriage).
4. Turn the forming pin in flanging position by means of the switch
and at the same
time turn the control switch of the tool to the position
.
5. Press the EMERGENCY STOP button completely down.
1. Key-switch (1=auto, 2=manual), 2. Brake release- push button,
6. Turn the key switch to the MANUAL position “2”.
¨
NOTE! The brake is released when the brake release push-button
is pressed down. The brake is engaged again when the push-button is
released.
7. Open the hood.
8. Press the
push-button down, which will release the brake.
¨
NOTE! Be careful when turning the forming device, because it has the
tendency to turn backwards, due to its eccentric mass.
9. Turn the forming device to its horizontal position, the adjustment unit will then point
to the side. Lock the forming device by releasing the brake push-button.
10. Turn the key switch to the AUTO position “1”.