Synectix ATT 2000, User Manual

Page: 16 / 56

To delete only one of the two extensions entered earlier, first delete both
extensions and then re-enter the required extension.
The mode of transfer to these extensions depends on the `transfer mode'
selected under program # 102.
The dialing plan for 0 and 9 are not allowed, since they are reserved for the
Operator extensions. It is also not necessary to enable the plan for digits in
a sequence. For example, the dialing plan may be enabled for digits 1, 4
and 8 only.
The Operator digit, (if other than 0 or 9) should not be part of the single digit
plan.
All the extensions that are entered here are treated as Valid extensions and
are not subject to the Invalid leading digit check or the Invalid extension
list check. The extension numbers may also be repeated between the plans
for different single digit plans.
Default: None
All single digit plans are disabled by default.
Program # 203:
This program prompts the Single digit plan for all digits that have been
programmed.
You will hear (for the example on previous page) -
Two Zero Three (0.6 sec silence) One (0.6 sec silence) One Two Seven Star
One Two Five Five (0.6 sec silence), Two (0.6 sec silence) Three Two Nine
One (0.6 sec silence) Four One Six (0.6 sec silence) Three (0.6 sec silence)
Two Zero One Star Four seven Two Zero…
Program # 104: Operator Extension
The user may program multiple extensions as “DAY Operator extensions”.
These extensions may be of different lengths. For example, you may enter
104 0
Þ
261
Þ
3564 #.
In the above example, one Single digit, one 3 digit and one 4 digit
extension has been programmed, Press Þ to separate two extensions.
Press # to terminate the entry. At least 1 digit must be programmed. For
example, the entry 104 1 # is a valid entry. However, the extensions
programmed here must be valid extensions for the PBX.
When a caller requests a transfer to the Operator extension, ATT 2000 dials
the first extension in the above list. If the unit encounters a busy / no
answer signal from the first extension, it tries the second and if even that is
busy / no answer, it tries the third extension in the list.
If a blind mode of transfer has been selected, the unit dials the first
16