Length of entry = fixed 5 digits
The Installer may also Listen to and reprogram the User password under
Program # 119.
Program # 620:
The currently programmed password is played back.
Program # 521:
Optional Extension Length
The ATT 2000 has the ability to accept extension numbers with variable
number of digits from 2 to 5 or it can be made to accept a fixed extension
length.
To use the variable extension length option, program the Length = 0 under
this program. In this case, whenever the caller dials an extension, it will
transfer the call after receiving 5 digits or if less than 5 digits are dialed, wait
for the conflict timer to elapse after the last digit has been dialed and then
transfer the call. Hence, if there are no 5 digit extensions and if 0 is
programmed, there will always be a delay of a few seconds (depending on
the conflict timer value), before the call is transferred and this may lead to
some confusion for the callers.
If all the extensions are of a fixed length, it is advisable to program the
value accordingly under this program. If the programmed value is 2 or 3 or
4 or 5, the unit waits for only that many number of digits to be dialed by
the caller and transfers the call immediately once all the digits are received.
Enter 521 n where n = 0, 2,3,4,5
Default value = 3
Length of entry = fixed 1 digit
Program # 621:
To listen to the currently programmed value for the Extension Length -
You will hear:
“Six Two One (0.6 sec silence) Three”
Program # 700, 800, 900
Program # 700, 701-724
Record all prompts and greetings (Through
phone line, remote recording)
You may record any of the default prompts remotely using this program.
The default prompt list is given at the end of this manual. To change the
default prompt of the second language in a multilingual set up, first set the
51
Summary of Contents for ATT 2000
Page 1: ......
