Symantec GHOST IMAGING FOUNDATION 7.1, Manual

Page: 143 / 189

The override switch allows the override of internal space and integrity checks and lets you
put a very big image into a small partition. The operation fails if it is unable to write to the
limited partition size. This switch lets you override spanning, which fails if there is limited
space. Avoid using this switch. -or
Saves the File Preservation Metadata File that holds the location of preserved files to a
specified location. By default, it is saved to the current directory.
For example:
ghost - pfile=c:\pathname
Where pathname is the directory for the File Preservation Metadata File.
-pfile
Specifies that the master boot record of the destination disk is to be preserved when
performing a disk-to-disk or image-to-disk operation. -pmbr
If Symantec Ghost has a choice, it attempts to use internal Ghost file system access as
opposed to using the operating system for file system access.
This switch is intended for use under instruction from Symantec Technical Support when
troubleshooting.
-prefghst
If Symantec Ghost has a choice, it attempts to use the operating system for file system
access as opposed to using the internal Ghost file system access.
This switch is intended for use under instruction from Symantec Technical Support when
troubleshooting.
-prefos
Preserves the specified files. The task fails if the specified files do not exist. To preserve
files or directories other than the image file, the syntax is as follows:
-preserve=filepath[=newpath] [,filepath[=newpath]...]
Each filepath can refer to an individual file or a directory. All files and subdirectories of a
specified directory are preserved. If a file does not exist, then the restore fails. After a Clone
step in a task, all preserved files are added back to the partition that is specified by
the-preservedest=n switch. Ghost renames them to newpath where it is specified. You must
use -preserve with -preservedest.
If you are running Ghost from a CD, you must use the -pfile switch with the -preserve
command. You also must specify a writeable location for the file-preservation metadata
file. Otherwise, Ghost tries to write the file-preservation metadata file to the CD. Because
the CD is read-only. the data cannot be written, and the process fails.
-preserve
Where n is the number of the partition relative to the destination disk, not relative to the
partitions being restored. Specifies the partition to which files specified with the preserve
switch are restored. -preservedest=n
Deletes a preserved image file once the restore has completed successfully. This switch
overrides the default, which is to retain the preserved image file. -preservedimage
deleteafterclone
143 Command-line switches
Command-line switches