Symantec GHOST IMAGING FOUNDATION 7.1, Manual

Page: 157 / 189

:PROBLEM
ECHO Symantec Ghost returned with an Error value 1 or higher
ECHO Symantec Ghost operation was not completed successfully
REM **Add any commands required to run if Symantec Ghost
REM fails here **
:FINISH
ECHO Batch File Finished
Using the -CRC32 switch
CRC checking works file-by-file with FAT partitions. NTFS partitions are
CRC-checked within an image file by each MFT table. It is not possible at present
to obtain a list of files failing a CRC check with an NTFS file system. When a CRC
file is created for an NTFS partition, only a single CRC value is generated. You can
also create a CRC file from an image file and verify it against a disk.
The full syntax for this switch is as follows:
-CRC32,action={create|verify|pcreate|pverify|dcreate|dverify},
src={{disk}|{partition}|{file}},crcfile={file}|{partition},vlist={file},
vexcept={file}
Table B-10 describes the parameters that can be used with the -CRC32 switch.
Table B-10
Parameters for the -CRC32 switches
Explanation Parameter
Create an ASCII CRC32 file from a disk create
Verify a disk from a CRC32 file verify
Create an ASCII CRC32 file from a partition pcreate
Verify a partition from an ASCII CRC32 file pverify
Create an ASCII CRC32 file from an image file dcreate
Verify an image file from an ASCII CRC32 file dverify
ASCII CRC32 file (default=Ghost.crc) crcfile
Verification list file (default=Ghost.ls) vlist
Verification exception file (no default) vexcept
157 Command-line switches
Using the -CRC32 switch