Symantec GHOST IMAGING FOUNDATION 7.1, Manual

Page: 151 / 189

Setting a source for the clone switch
The syntax for this switch is as follows:
SRC={disk | file | multicast | tape | cd writer }
SRC defines the source for the operation that is selected by the clone mode option.
Table B-6 lists the source switches.
Table B-6
Source options for cloning
Explanation Source Switch
Source disk drive number. Numbers start at 1.
For example:
SRC=1
A partition on a drive can also be specified.
Numbers start at 1. For example:
SRC=1:2
drive number disk
The source image file name. For example:
SRC= g:\source.gho
A partition in an image file can also be specified.
For example:
SRC=g:\source.gho:2
Files can also be read from a CD-ROM drive.
The following files types are supported: .gho,
.vmdk, .pqi, .v2i, .iv2i.
Note: .pqi, .v2i, and .iv2i are only available in
Ghost32 with the v2idisklib.dll present.
filename file
The name of the multicast session. @mcsessionname multicast
The tape drive number. Numbers start at 0. For
example:
SRC=@MT0
A partition on a tape can also be specified. For
example:
SRC=@MT0:3
@MTx tape
151 Command-line switches
Using the clone switch