Table 10-25
Options on the
Update ASF Configuration Settings
task page
(continued)
Description
Option
Check to modify the settings in this group when the
task runs.
Modify timers settings
Check to watch for operating system hangs and type
the watch interval in seconds. Default: 30 seconds.
Enable OS hang watchdog
If you want the network adapter to ping the
management console, check this option and type the
ping interval in seconds. If the ping fails, the agent
goes into safe mode. Default: 30 seconds.
Enable ping to management
console
Check to modify the settings in this group when the
task runs.
Modify spanning tree settings
Check this option if you want the network adapter to
ping the management console after the link is
temporarily lost and then restored. Type the interval
in seconds and the count of pings. Default: 10 seconds,
3 times.
Ping destination on link reconnect
Check this option if you want to delay sending events
to the management console after the link is restored:
for example, if the network traffic is high. Type the
number of seconds to wait. Default: 10 seconds.
Delay sending Platform Event
Traps on link reconnect
Check to modify the settings in this group when the
task runs.
Modify remote control settings
Check to enable a low latency reset of the system.
ASF Reset
Check to enable unconditional power-down (occurs
without any blocking from software or system).
ASF Power down
Check to ensure that the sleeping system can be
remotely turned on.
ASF Power up
Check to enable a hard reset of the system. This reset
is functionally equivalent to an unconditional
power-down operation, followed by a power-up.
ASF Power cycle
Check to modify the settings in this group when the
task runs.
The settings in this group are applied to the computers
with Broadcom ASF only.
Modify Broadcom ASF adapter
settings
About Out of Band Management Component pages
Update ASF Configuration Settings task
158
