35
Appliance setup and initial system configuration
Adding the default gateway
8
To verify the definition, type the following command:
ip show
Command completed successfully
Adding the default gateway
This section explains how to add the default gateway from the command-line.
You must define a default gateway to access the Web-management interface
from a different subnet.
Note:
If a computer with a Web browser is connected to the same subnet as the
Clientless VPN Gateway, you may complete the configuration using the Security
Gateway Management Interface instead of using the command-line interface as
shown here. See the
Symantec Clientless VPN Gateway Administrator’s Guide
for
more information.
Adding the default gateway
1
On your console computer, to display the routing rules, type the following
command:
route show
Command completed successfully
The InterfaceID number is the Ethernet port number as labelled on the
Clientless VPN Gateway.
2
To create a default gateway, type the following command:
route create ip=0.0.0.0 \
netmask=0.0.0.0 gateway=Gateway_IP
Command completed successfully
The Gateway_IP is the IP address of the default gateway.
Interface
IP
Netmask
1
SCVG_IP
SCVG_Mask
IP
Gateway
Netmask
InterfaceID
SCVG_IP
0.0.0.0
SCVG_Mask
1
Summary of Contents for 4400 Series
