Symantec 4400 Series, Installation Manual

Page: 18 / 100

14 Installing the appliance
About model 4460
Table 2-2 lists the model 4460 back panel.
Connecting model 4460 to the network
The Clientless VPN Gateway model 4460 offers two usable gigabit Ethernet
connections. You must configure the inside and outside interfaces as int0 and
int1 respectively.
To connect models 4460 to the network
1 Plug the RJ-45 connector from the LAN into the inside interface int0
network connection (6 top).
2 Plug the RJ-45 connector from the Internet into the outside interface int1
network connection (6 bottom).
Connecting the power cord to models 4460
The following procedure describes how to connect the power cord. Use the
location numbers from
Figure 2-2 to refer to the back panel mentioned in each
step.
Table 2-2 Model 4460 back panel
Location Feature Description
1
(top)
Master power switch Turns the appliance on or off.
1
(bottom)
Power socket Connection for AC power cord.
2 Cooling fan Maintains proper operating temperature. Ensure
that the ventilation holes in the front and back
are not blocked.
3 Power reset switch Resets appliance.
4 USB ports The USB ports are currently unsupported.
5 Serial console port
(115200 bps) Lets you connect a terminal emulator to act as a
system console and lets you log on to the system
console and access the Command-line Interface
(CLI).
6 int0 (top)
and int1(bottom)
Accepts a 10/100Base-T network cable, which
enables Ethernet network connection. int0 is the
inside interface and int1 is the outside interface.