Symantec 4400 Series, Installation Manual, Page: 37 / 100

33 Appliance setup and initial system configuration
Configuring the Ethernet port
Uniform command formats
Commands always start with an object followed by the action and then attribute
value pairs:
This example shows the definition of network interface 1.
ip show interfaceID=1
Command completed successfully
Auto-complete
Auto-complete lets you enter the first few letters and then press tab to auto-
complete a command.
Auto-list
If there are multiple possible completions, press tab again to see a list.
Example:
To display a list of all objects, press tab twice without entering data.
Configuring the Ethernet port
You can reconfigure the Clientless VPN Gateway internal Ethernet port (int0)
from the command-line interface. The the Clientless VPN Gateway internal
Ethernet port (int0) is first configured during the LCD setup. See
“Performing
the initial appliance network setup” on page 24.
To configure an Ethernet port
1 Open a command-line session on the console from the computer to the
Clientless VPN Gateway.
object action name1=value1 name2=value2
Interface IP Netmask
1 172.16.0.1 255.255.255.0
i
interface ip