13
Installing the appliance
About model 4460
Connecting power cord to model 4420
Use the location numbers from
Figure 2-1
to refer to the back panel mentioned
in each step.
To connect power to the appliance model 4420
1
Plug the power cord into the power socket on the rear panel (2).
2
Connect the power supply cord from the appliance to an electrical outlet or
UPS supply unit.
Turning on the power for model 4420
Turn on the power by pressing the master power switch (3) on the back of the
Symantec Clientless VPN Gateway 4400 Series. See
“Connecting model 4420 to
the network”
on page 12. The appliance has powered up properly when the
following things happen:
■
The hard disk spins, the fans turn on, and the LEDs and LCD screen on the
appliance light up.
■
A number of status messages and Symantec CVG 5.0 display on the LCD
screen when the appliance completes its start process.
About model 4460
This section describes the back panel features of the Clientless VPN Gateway
model 4460. Model 4460 offers two 10/100/1000 Gigabit Ethernet ports. There
are four inactive ports for future expansion. Refer to
Figure 2-2
for a back panel
view of the 4460.
Figure 2-2
Models 4460 back panel
Summary of Contents for 4400 Series
