Symantec 4400 Series, Installation Manual

Page: 29 / 100

25 Appliance setup and initial system configuration
Performing the initial appliance network setup
2 When the system messages display on the LCD, press any arrow button to
display the 1. Network system menu option.
3
Press e to start the network setup.
4 Under Select Interface, use the left or right arrow button to select Interface
0 or Interface 1 for your management interface.
5 Press e .
6 Under Int0 IP Address, enter the inside IP address.
Each octet of the IP address is a separate field in the display. Use the left
and right buttons to move between the fields of the IP address. The selected
field is surrounded by brackets ( [ ] ). Use the up and down buttons to change
the number in the field that is selected.
7 Press e .
8 Under Netmask, enter the netmask address for the IP address you just
entered.
Each octet of the netmask address is a separate field in the display. Use the
left and right buttons to move between the fields of the IP address. The
selected field is surrounded by brackets ( [ ] ). Use the up and down buttons
to change the number in the field that is selected.
9 Press e .
10 Under Default Gateway, enter the default gateway IP address.
Each octet of the netmask address is a separate field in the display. Use the
left and right buttons to move between the fields of the IP address. The
selected field is surrounded by brackets ( [ ] ). Use the up and down buttons
to change the number in the field that is selected.
11
Press e .
12 Under Save Setup, use the left or right buttons to select one of the
following:
13 Press e .
[Yes]
This generates the administrator password. A new password is generated
each time you save this setup from the front panel. Use this password to
log in to the SGMI or the CLI.
You can change the passwords using the SGMI or CLI.
[No] The configuration is not saved, the system restarts, and all your information is
lost. The default selection is [No]. If you select [No], you will exit setup when
you press e.