Sylvac D 100S, Instructions For Use Manual

Page: 11 / 76

11
+ +
6/ Select language by pressing
2
then
2
then
3
and then 1,2 or 3 (
see chap.. 1.6.11
).
This selection is memorized permanently by the unit (along with all other data).
7/ Where necessary, convert from metric to imperial measurement by pressing
mm/inch
key.
8/ Specify the readout resolution by pressing
Resol
key and then 1,2,3 or 4 (
Section 1.6.4
).
9/ If required (
refer to Section. 1.6.3
) :
Reverse direction of probe measurement. (
C (+/-
))
Select diameter mode (* 2)or any other multiplication factor. (
C Channel
)
Select measuring channel if several probes (or channels) are used, and A +/- B or A+/-B+/-C mode if necessary.
Change probe – channel allocation or allocate a channel to an Opto-RS232 instrument.
10/ If required, connect the foot pedal or other external contact (
section 1.8.6
) and assign its function(
refer to section
1.6.11
). It is also possible to connect a printer to the Centronics output (
section 1.8.1
) and set up transmission
parameters (
section. 1.6.14
). It is equally possible to connect an analog printer to the analog output (
section
1.8.3
) and command devices (
e.g. electro-valve
) on sort outputs (
section 1.8.3
). It is possible to use a D110
vacuum pneumatic lifting unit (
section 5
) and configure the external contact (
section 1.6.11
) in order to lift/lower
probes.
11/ Reset display to zero or to any probe reference value by pressing
Preset
key. The stored preset value may be
entered with
Setup
key then
Preset
key (
section. 1.6.10
).
12/ The displayed measurement can be accompanied by :
the analog scale (
section 1.6.6
)
tolerances (
section 1.6.7
) or classification (
section 1.6.8
) indicators.
min/max mode (
section 1.6.12
)
store mode for statistics (
section 1.6.15 and 1.6.9
)
scanning mode if one or more D102/D108/D104 units are used. (
section 1.6.13
).
13/ Once the unit has been set up, the keyboard can be locked. The external contact and
Print
key remain active.
The mm/inch function can also be locked.