22
g)
Deleting the user fingerprint
The respective user will no longer have access and the corresponding user fingerprint can be deleted. Deletion is
possible either via the user fingerprint or the memory number.
The master transponder or the master fingerprint can also be used to delete a user fingerprint.
1) Deletion of a user fingerprint with the IR remote control
• Start programming mode as outlined in 8. a) so that the LED flashes red.
•
Enter programming code to start deletion mode. The LED lights up yellow.
•
There are 2 different ways to delete:
-
Touch the fingerprint sensor with the user finger you wish to delete. If the fingerprint is recognised, the access
system emits a short beep and the fingerprint is deleted.
-
Enter the memory number of the user fingerprint (without leading zero for single-digit memory numbers) and
confirm it with the
button.
If the user fingerprint is not known in the system and, therefore, deletion is not possible (or the entered
memory number is already blank), the access system emits 3 quick beeps and the LED flashes red.
• If you wish to delete additional user fingerprints, proceed as outlined.
•
Exit deletion mode with the
button. The LED flashes red again. You can now carry out further programming or
exit programming mode with the button.
2) Deletion of a user fingerprint with the master transponder or the master fingerprint
•
Hold the master transponder 2x in succession a short distance in front of the RFID sensor or touch 2x with the
master finger on the fingerprint sensor. The access system emits a short beep and the LED lights up yellow.
• Touch the fingerprint sensor with the user finger you wish to delete. If the fingerprint is recognised, the access
system emits a short beep and the fingerprint is deleted.
If the user fingerprint is unknown (or already deleted), the access system emits 3 quick beeps and the LED
flashes red.
• If you wish to delete additional user fingerprints, proceed as outlined (touch the fingerprint sensor 3x in succession).
•
To end the deletion process, hold the master transponder 1x in front of the RFID sensor or touch 1x with the master
finger on the fingerprint sensor. The LED then lights up red and the access system is in standby mode again.
•
