12
8.
Operation
a)
IR remote control
The IR remote control battery is already inserted on delivery. Simply remove the small transparent protective strip (this
prevents premature discharge of the battery) and the IR remote control will be ready for operation.
The battery will need to be replaced if the access system no longer responds to the IR remote control.
In that case, simply remove the battery holder at the bottom end of the IR remote control and replace the depleted
battery (1x CR2025) with a new one. The positive terminal (+) of the battery must point towards the bottom of the IR
remote control.
Insert the battery holder into the IR remote control, observing the correct orientation.
Dispose of batteries with respect to environmental protection; see ‘Disposal’.
b)
Access system
After completing the installation and connection process, switch on the operating voltage. The access system emits
a short beep and the LED lights up red. This indicates that the access system is in standby mode. You can now start
programming, see next chapter.
If the access system continuously emits beeps and the LED flashes quickly, the brightness sensor on the
rear has activated the sabotage protection; operation is not possible.
Disconnect the access system from the operating voltage immediately in this case. Ensure that the bright-
ness sensor is in the dark after installation.
If you wish to commission the access system for testing purposes before mounting, cover the brightness
sensor on the rear, e.g. use a piece of opaque adhesive tape (if necessary, briefly disconnect the access
system from the operating voltage to reset the sabotage protection).
