21
2) Teach-in of a user fingerprint with the master transponder or the master fingerprint
This teach-in process is very fast and easy, new user fingerprints are taught in to the next available mem
-
ory.
In this case, however, deleting a specific user fingerprint is only possible with the fingerprint as the assign
-
ment between the user fingerprint and memory number is unknown. In that case, all memories would need
to be deleted.
• Hold the master transponder 1x at a short distance in front of the RFID sensor or touch 1x with the master finger on
the fingerprint sensor. The access system emits a short beep and the LED lights up yellow. Teach-in mode is active.
• To teach in a user fingerprint, touch the fingerprint sensor 3 times in succession with the same finger. An LED ring
around the sensor lights up blue when the sensor is touched. The LED ring lights up green and a short beep is
emitted if the fingerprint is recognised correctly. After the third correct reading, the access system emits a longer
beep and the fingerprint is stored.
If the fingerprint cannot be read correctly, 3 beeps are emitted and the LED ring flashes red. The same
happens if you try to read in a fingerprint that has already been stored.
• You can now teach in another user fingerprint, proceed as outlined above (touch the fingerprint sensor 3x in
succession).
•
To end the teach-in process, hold the master transponder 1x in front of the RFID sensor or touch 1x with the master
finger on the fingerprint sensor. The LED then lights up red and the access system is in standby mode again.
