Swann AMI Turbitrack, Manual

Page: 45 / 72

A-96.250.231 / 130421
AMI Turbitrack
Troubleshooting
45
E014 Case Temp. low
– check case/environment temperature
– check programmed value 5.3.1.5, p. 60
E017 Control Timeout
– check control device or programming in
Installation, Relay contact, Relay 1 & 2
5.3.2 & 5.3.3, p. 61
E018 Turbi disconnected
– shut off power
– check wiring
E024 Input active
– See If Fault = Yes is programmed in
Menu 5.3.4, p. 65
E026 IC LM75
– call service
E028 Signal output open
– check wiring on signal outputs 1 and 2
E030 EEProm Frontend
– call service
E031 Calibration Recout
– call service
E032 Wrong Frontend
– call service
E033 Power-on
– none, normal status
E034 Power-down
– none, normal status
E068 Replace absorber
(dew point inside the
turbidimeter housing is
3 °C or higher)
– call the <Maintenance>/<Replace
Absorber> menu item
– replace the humidity absorber, see
Replacing the Humidity Absorber, p. 38
Error Description Corrective action